Raymarine 465 Especificaciones descargar pdf (Pagina 54)

40 RC435 and RC435i Chartplotters

Anchor Alarm

The selected value is used as the anchor alarm distance. If the vessel

moves outside of the selected distance from its position (at the time that

the alarm was enabled) the alarm sounds and an alarm message is

displayed.

To silence the alarm, press any key. This removes the warning and resets

the distance. The alarm will not be triggered again unless the vessel

moves the selected distance from its position (at the time that the alarm

was turned off). The alarm is set to OFF on power up.

XTE Alarm

The selected value is used as the cross track error limit. The alarm is

triggered when the cross track error exceeds the selected limit when a

GOTO or a Route Follow is in progress and an alarm message is displayed.

Select Chart

Use SELECT CHART to access different charts from the same Gold Card.

Use the trackpad up/down buttons to select the desired chart and press

ENTER to load this as the active chart.

Note: Only one chart can be active at any one time.

Chart Text

When ON, Chart text (such as place names) are shown on the screen. The

selected setting is retained when the unit switched off.

LOAD

CHART

"ENTER" TO LOAD

"CLEAR" TO QUIT

D6249-1

1G737T32-FLORIDA SE

81236_1.book Page 40 Monday, January 5, 2004 3:41 PM

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 131 132

Sin comentarios

Raymarine 465 Especificaciones Pagina 54