Raymarine 465 Especificaciones descargar pdf (Pagina 27)

Chapter 2: Installation 17

2.5 Running the Cable

Introduction

The minimum requirements are a power cable and (for the RC435 only) a

connection from the GPS Antenna. Additional cables will be required if

connecting to other equipment.

Notes: (1) All cables should be adequately cleated and protected from

physical damage and exposure to heat. Avoid running cables

through bilges, doorways or close to moving objects or heat

sources.

(2) Where a cable passes through an exposed bulkhead or deck-

head, a swan neck tube should be used.

Connectors

Antenna Connector

The ANTENNA connector provides power and RF connection to the

associated GPS Antenna.

CAUTION:

Do not connect/disconnect the GPS Antenna from the display unit

while power is applied. Such action could cause irreparable damage.

➤ Connect the antenna using the attached cable, as follows:

1. If not already installed, mount the GPS Antenna Section 2.3.

2. Feed the cable through to the rear of the Chartplotter.

3. Coil up any unused cable in an appropriate safe space out of view. Do

not bend the cable tighter than 100mm (4in) radius.

4. Screw the cable connector fully into its mating connector on the

Chartplotter.

5. Ensure that the protective boot covers the connector.

Note: If the supplied cable is too short, use an extension cable

(Part# E36011), or consult your Raymarine dealer.

It is recommended that only a single extension cable is used as each extra

connector will reduce signal levels.

81236_1.book Page 17 Monday, January 5, 2004 3:41 PM

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 131 132

Sin comentarios

Raymarine 465 Especificaciones Pagina 27