Raymarine 465 Especificaciones descargar pdf (Pagina 18)

8 RC435 and RC435i Chartplotters

• The equipment is supplied from a separate battery from that used for

engine start. Voltage drops below 10 V, and starter motor transients,

can cause the equipment to reset. This will not damage the equip-

ment, but may cause the loss of some information and may change the

operating mode.

• Raymarine specified cables are used. Cutting and rejoining these

cables can compromise EMC performance and must be avoided

unless doing so is detailed in the installation manual.

• If a suppression ferrite is attached to a cable, this ferrite should not be

removed. If the ferrite needs to be removed during installation it must

be reassembled in the same position.

Suppression Ferrites

The following illustration shows typical cable suppression ferrites used

with Raymarine equipment. Always use the ferrites supplied by

Raymarine.

Figure 2-1: Typical Suppression Ferrites

Connections to Other Equipment

If your Raymarine equipment is to be connected to other equipment using

a cable not supplied by Raymarine, a suppression ferrite MUST always

be attached to the cable near to the Raymarine unit.

D3548-5

81236_1.book Page 8 Monday, January 5, 2004 3:41 PM

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 131 132

Sin comentarios

Raymarine 465 Especificaciones Pagina 18