Raymarine SmartPilot SPX-30 Manual de instalación descargar pdf (Pagina 28)

Auto trim

The AutoTrim setting determines the rate at which the SmartPilot X system applies

‘standing helm’ to correct for trim changes caused by varying wind loads on the sails

or superstructure.

The default AutoTrim is set as part of the Autolearn process.

If you need to change the setting, increase the

AutoTrim one level at a time and use the lowest

acceptable value:

• If the SmartPilot X system gives unstable

course keeping or excessive drive activity with

a change in the heel angle, decrease the

AutoTrim level.

• If the SmartPilot X system reacts slowly to a

heading change due to a change in the heel

angle, increase the AutoTrim level.

• If the AutoTrim level is too high, the boat will be less stable and snake around the

desired course.

1. Use < or > to increase or decrease the setting.

2. Press

ENTER

to accept the new value.

Auto turn (motor boats only)

This setting defines the amount of course change

when performing an auto turn.

1. Use < or > to increase or decrease the setting.

2. Press

ENTER

to accept the new value.

Setting Effect

OFF

No trim correction

Auto trim applied:

1 = Slowest, 6 = Fastest

Press ENTER to select.

Auto Trim

D10880-1

The amount of standing rudder

applied to compensate for wind drift.

Press ENTER to select.

Auto Turn

D10881-1

Define the course change when

performing an Auto Turn.

81287_1.book Page 20 Tuesday, March 18, 2008 11:50 AM

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Comentarios a estos manuales

Sin comentarios

Raymarine SmartPilot SPX-30 Manual de instalación Pagina 28

Comentarios a estos manuales