Raymarine SmartPilot SPX-30 Manual de instalación descargar pdf (Pagina 22)

Compass swing

You will need to turn your boat in slow circles while the system automatically makes

adjustments to account for compass deviation. Each 360-degree circle should take

no less than two minutes, and you should complete at least two circles.

1. Press

ENTER

and begin to turn your boat in

slow, even circles. Keep speed to below 2

knots. Watch the display to ensure you are not

turning too fast. If the message ‘Slow Down’ is

displayed you will need to slow down.

2. When the compass has been calibrated, a

message will be displayed showing the

detected deviation. If this is more than 5

degrees you will need to abort the calibration

process and resite the compass further away from metal items, then repeat the

calibration process.

If you still find a deviation of more than 5 degrees, contact your Raymarine dealer

for advice.

If the deviation is within acceptable limits, press

ENTER

to continue calibration.

Compass alignment to GPS

Note: Systems without a GPS will skip this section and go straight to Manual compass align-

ment on page 14.

If your system has a GPS connected to your data network (SeaTalk, SeaTalk

NMEA), the autopilot is tuned to the GPS heading while you steer to a known

magnetic heading. This step provides a rough alignment and minimizes the amount of

compass fine tuning required.

1. When the vessel has performed sufficient

turns to complete compass linearization, the

following display should be shown.

2. Steer the boat on steady course and

accelerate to more than 3 knots.

3. Follow the on-screen instructions until the

screen displays the ‘OK’ message, then press

ENTER

to continue.

Manual compass alignment

1. Continue to steer on a steady course and use

the Use

and

-1

buttons to adjust the heading

displayed until it matches the ship’s compass

reading.

2. Press

ENTER

to continue.

Press ENTER to start.

Compass Calibration

D10882-1

Move in a slow circle.

Press CANCEL to exit.

Press ENTER to continue.

Align to GPS

D10875-1

Steer the boat on a steady course.

Press CANCEL to exit.

Press ENTER to accept.

Compass Alignment

10874-1

Use +1 and -1 buttons to adjust

the heading.

220°

81287_1.book Page 14 Tuesday, March 18, 2008 11:50 AM

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Comentarios a estos manuales

Sin comentarios

Raymarine SmartPilot SPX-30 Manual de instalación Pagina 22

Comentarios a estos manuales