Raymarine ST50 plus Manual de usuario descargar pdf (Pagina 8)

ST50 Plus

Ttidata

and Repeater Operation and Installation Handbook

The rear case is fitted with a foam gasket to form a water-tight seal between

the instrument and the selected installation face.

Cable boss 2

Feting

studs 3 Thumb nuts 4 Gasket

01250

Mounting Procedure

Note: Because the instrument breathes through the vent in the rear case, this

bracket is for interior use only.

1. Make surethat the selected location is clean, smooth and flat.

Flush Mounting

mark the centres for the fixing studs (2) and the cable boss (1).

Drill two 4mm (5/32inI clearance holes for the fixing studs (2) through

the bulkhead. Remove the template.

4. Cut the clearance hole for the cable boss

(11

using a 50mm (2in)

diameter cutter.

5. Screw the two fixing studs (2) into the control head.

6. Pass the SeaTalk cable and transducer tailsthroughthe cableboss

(

clearance hole.

7. Assemble the control head to the bulkhead and secure from behind

using the thumb nuts (3).

2. Applythe self-adhesive template (supplied) to the selected location and

Chapter 1: Control Head Installation

Bracket Mounting

The ST50 Plus TridaWRepeater can, as an afternative, be bracket mounted

using the Autohelm Mounting Kii (Cat. No.

D130).

A flush mounting kii is available for installations where a flush mount is required

or more desirable. Full installation instructions are provided with

the kit(Cat. No.

D183).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 24 25

Ff 27 Mar 2025 | 12:48:45

Notice st50

Raymarine ST50 plus Manual de usuario Pagina 8