Raymarine ST50 plus Manual de usuario descargar pdf (Pagina 20)

ST’50

plus

Tridata and Repeater Operation and Installation Handbook

Chanter

Calibration

Log Calibration

The ST50 Plus Tridata should not be used for navigational purposes until the

speed transducer paddlewheel has been calibrated to the vessel. This is a

simple operation that can be carried out automatically over a measured

distance or by manually entering a calibration factor.

Automatic Calibration

Automatic calibration should be carried out when tidal flow is at a minimum.

Locate an easily identified, marked and measured distance on a chart and

enter this distance into the instrument (4).

Note:The

measured distance should, ideally, be between 1 and 2.5

Nm/Miles

Proceed from object 1 to object 2 (measured distance), pressing

the SPEED

key at the start and finish of the run

and

6).

The calibration factor is

calculated and displayed atthe end of each run

(7).

Repeat the run over the measured distance intfre opposite direction. Once

again the calibration factor will be displayed. This represents the average

for the two runs. A further two runs can be made if required.

Don’t forget

to store the log calibration factor.

Note:The

log calibration range is from 0.25 to 2.00. Calibration factors

outside of this range cannot be stored.

SPEED

LOG DISTANCE

RUN START

RUN END

CALIBRATION

FACTOR

Note: Once you have completed the runs, store the calculated calibration

factor by pressing

DEPTH

and

SPEED

together until the displays returns to

normal mode (approximately 2 seconds).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25

Comentarios a estos manuales

Ff 27 Mar 2025 | 12:48:45

Notice st50

Raymarine ST50 plus Manual de usuario Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Raymarine ST50 plus