Raymarine ST50 plus Manual de usuario descargar pdf (Pagina 13)

ST50 Plus

Tridata

and Repeater Operation and Installation Handbook

ChaDter 4: ODeration

.2 Maintenance

Instrument

Certain atmospheric conditions may cause condensation to form on the

control head window. This will not ham-r the instrument and can be cleared by

increasing the illumination setting to Level 3.

Chemical and abrasive materials must not be used to clean the ST50 Plus

Tridat@epeater

instrument; if it is dirty, clean with a soft, damp cloth.

Transducer

Refer to the Installation and Maintenance instructions supplied with the

transducer.

Cabling

., . .

Examine all cables for chafing or damage to the outer shield and, where

necessary, replace and resecure.

Advice

For advice, or further information regarding the installation of this product,

please contact the Autohelm product Support Department or your own

National Distributor.

Chapter 4: Operation

As it leaves the factory the ST50 Plus Tridata is set to:

display speed in knots

display depth in feet

display distance in miles

master mode

‘CODE Lock’ switched off

Other factory default settings are:

shallow alarm set at 10 feet (disabled)

deep alarm set at 100 feet (disabled)

These settings can be changed in calibration, Chapter 6.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 24 25

Ff 27 Mar 2025 | 12:48:45

Notice st50

Raymarine ST50 plus Manual de usuario Pagina 13