Raymarine ST70 Instrument Guía de instalación

ST70 InstrumentInstallation GuideDocument reference: 87079-1Date: May 2007

2

Chapter 2: Planning 3Chapter 2: Planning2.1 System overviewsThe ST70 instrument is connected to the boat’s data system, which could be SeaTalkng or Se

4SeaTalkIn a SeaTalk system, the ST70 instrument is connected to existing instruments using a SeaTalkng to SeaTalk adapter cable; wind, speed and dept

Chapter 2: Planning 52.2 Positioning the ST70 instrumentCAUTION: Instruments must be placed a safe distance from equipment that could adversely effec

62.3 Parts suppliedD10399-1ST70 instrument (Part Number E22105)Panel seal (Part Number R28200)Stud (x 4)SeaTalkng blanking plug(Part Number A06032)Fin

Chapter 2: Planning 72.4 Parts not suppliedST70 instruments are connected to a SeaTalk or SeaTalkng data system. To install the instrument to your sys

8

Chapter 3: Installation 9Chapter 3: InstallationRead Planning on page 3 of this guide before you install the instrument. It helps you to:• Ensure you

10For SeaTalk:• Label both ends of the SeaTalkng-to-SeaTalk adaptor cable, and attach it to an existing instrument or connect it to a connector block

Chapter 3: Installation 113. Fit gaskets and bracketsNote: Stick the self-adhesive side of the gasket to the instrument, NOT to the mounting location

ii

12Flush mountingD10403-1self adhesiveside

Chapter 3: Installation 134. Attach connection cable to the instrument3. Rotate collar clockwise (2 clicks) until it snaps into the LOCKED position 1.

143.2 Install transducersTransducers and pods are available for wind, depth and speed. For detailed installation instructions refer to documentation s

Chapter 3: Installation 15SeaTalkCAUTION: Using the wrong type of pod could cause damage to your equipment. Before you connect a transducer to a pod,

16

Chapter 4: Technical specifications 17Chapter 4: Technical specificationsNote: System components have a Load Equivalency Number (LEN), which contribu

18

Chapter 5: Templates 19Chapter 5: TemplatesInstrument edgeSun cover edgeDrill hole,9/32 in (7 mm) diameter in4 positionsUPRemovematerialfrom shadedare

20Instrument edgeSun cover edgeDrill hole,3/16 in(5 mm) diameter in2 positions1.53 in (38.89 mm)1.53 in (38.89 mm)1.53 in (38.89 mm)1.53 in (38.89 mm)

Contents iiiContentsChapter 1:Before you begin ... 11.1Installation overvie

iv

Preface vContentsPrefaceWarnings and cautions Electromagnetic Compatibility (EMC) conformanceRaymarine equipment a

vi• Place Raymarine equipment and cables at least 3 ft (1 m) from any equipment that transmits, or cables that carry, radio signals from VHF radios, c

Preface viiTo the best of our knowledge, the information in the product documents was correct when they went to press. However, Raymarine cannot acce

viii

Chapter 1: Before you begin 1Chapter 1: Before you beginThe ST70 instrument must be installed correctly. For a safe and successful installation, we re