Raymarine VolvoPenta IPS Autopilot System DPU Manual de instalación descargar pdf (Pagina 66)

56 SmartPilot Series Commissioning Guide

System reset

WARNING: Losing settings at system reset

Do NOT use this feature unless advised to do so by a Raymarine

dealer. If you complete a reset you will lose ALL SmartPilot

calibration settings. You will then need to repeat the SmartPilot

commissioning process.

Selecting System reset will reset all of the calibration values:

• all of the settings in User Calibration, Seatrial Calibration and Dealer Calibra-

tion will return to the factory default values

• the settings in Display Calibration will not change, as these are stored in each

individual controller

To reset the system:

1. Select the System reset (RESET) screen in Dealer Calibration.

2. Press the +1 key (on ST8001 & ST8002, turn the rotary control clock-

wise and press auto)

3. The screen will then show an ARE YOU SURE message:

• press the +1 key again to select ‘YES’ and reset the SmartPilot

(on ST8001 & ST8002, turn the rotary control clockwise and press

auto)

• alternatively, press the disp key to cancel

4. You will then see the CAL LOCK screen:

• press standby for 2 seconds to save the new default settings, then turn

the SmartPilot computer power off and back on

81273_1.book Page 56 Monday, December 5, 2005 10:32 AM

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 79 80

Sin comentarios

Raymarine VolvoPenta IPS Autopilot System DPU Manual de instalación Pagina 66