Raymarine VolvoPenta IPS Autopilot System DPU Manual de instalación descargar pdf (Pagina 17)

Chapter 1: System Connections 7

6. Connect the drive cables to the MOTOR inputs. These cables can be con-

nected any way round as their orientation is verified later in the process.

Grounding the SmartPilot

S1 Systems S2 & S3 Systems

CAUTION:

S1 systems MUST be connected to

ships ground.

Failure to connect the SmartPilot to ships

ground may cause it, or other on-board

electronics to function incorrectly.

• U se fl at t in ne d c op p er b ra id , 3 0 A r at in g ( ¼

in) or greater. Equivalent stranded wire

diameter 4mm or greater.

• Using the supplied yellow (¼ in) female

spade connector, connect the braid to

RF GND on the SmartPilot computer.

• The other end of the earth strap should be

connected to metal in contact with the

water. If this is not possible, it can be con-

nected to the negative pole of the battery

(ideally at the battery itself).

• Keep the length of the earth strap as short

as possible

CAUTION:

S2 & S3 systems MUST NOT be

connected to ships ground.

If the installed location has a metallic sur-

face, you must insulate the base of the

computer so it is not earthed.

MOTOR

D6392-1

RF GND

MOTOR

POWER

D6378-1

S1 systems only

81273_1.book Page 7 Monday, December 5, 2005 10:32 AM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 79 80

Sin comentarios

Raymarine VolvoPenta IPS Autopilot System DPU Manual de instalación Pagina 17