Raymarine E Series Manual de instalación Pagina 1

E-Series Networked DisplayInstallation ManualDocument Number: 87043_1Date: December 2004www.busse-yachtshop.de | [email protected]

iv E-Series Installation Manualwww.busse-yachtshop.de | [email protected]

Chapter 1: Preparation for installation 1Chapter 1: Preparation for installation1.1 General informationIntended useThis handbook provides information

2 E-Series Installation ManualContents of this packThe E- Series (E80 or E120) Networked Display pack contains the following items:Pack details

Chapter 1: Preparation for installation 3DimensionsThe dimensions for your E-Series display are:E80 Display E120 Display CANCE

4 E-Series Installation ManualAccessories and sparesRaymarine accessories and parts can be obtained from your authorized Raymarine dealer. However, if

Chapter 1: Preparation for installation 51.2 Planning the installationThis section provides information and advice for planning the installation of yo

6 E-Series Installation ManualSuppression Ferrites The illustration shows typical cable suppression ferrites used with Raymarine equipment.

Chapter 2: System Integration 7Chapter 2: System IntegrationIntroductionThis chapter provides an overview of system integration, you may find that you

8 E-Series Installation Manualdevices to talk to each other, whilst maintaining near transparent NMEA 2000 compatibility. What is SeaTalk High Speed?S

Chapter 2: System Integration 92.2 CompatibilityRadar ScannersCAUTION: Radar Scanners, Cables & InstallationInformation on radar scanners, cables

Trademarks and registered trademarksAutohelm, HSB, Raymarine, RayTech, RayTech Navigator, Sail Pilot, SeaTalk and Sportpilot are registered trademarks

10 E-Series Installation ManualMedia storage cardsNavionics Chart cardsTo use your E-Series Display as a navigation aid, charts with detailed informat

Chapter 2: System Integration 112.4 How is an E-Series integrated?You can integrate:• A single E-Series display.OR:• Connect two E-Series displays or

12 E-Series Installation ManualSingle display systemThis simple system incorporates a single E-Series display with a DSM 300 and radar. Po

Chapter 2: System Integration 13Networking E-Series DisplaysYou can connect two or more E-Series Displays to create a network. This will enable you to

14 E-Series Installation ManualA typical two node system incorporating two displays Power CablesRed 12V or 24V DCBlack 0VGround/Ea

Chapter 2: System Integration 15An example of a three (or more) node systemTo: Fast heading sensor NMEA GPS DSC radioTo: SeaTalk system Remote alarm

16 E-Series Installation Manualwww.busse-yachtshop.de | [email protected]

Chapter 3: Installation 17Chapter 3: InstallationCAUTION: Please ensure that you have read Chapter 1: Preparation for installation before proceeding.

18 E-Series Installation Manuali. Locate the front cover clip-on over the front of the display - see page 20.ii. Check that the buttons have passed th

Chapter 3: Installation 19Flush mounting the DisplayYou should flush mount your display as follows:.1. Check the selected location for the unit. A cle

Table of ContentsChapter 1: Preparation for installation ...11.1 General information

20 E-Series Installation ManualHow is the front cover clip-on attached to the display?The front cover clip-on is attached as follows: 1. C

Chapter 3: Installation 21How do I remove the front cover clip-on? To remove the clip- on front cover:1. To prevent damaging your dash or

22 E-Series Installation Manual3.2 CablesThis section details how to instal and connect all the relevant cables to your E-Series Display.Siting and se

Chapter 3: Installation 23How are the cables connected to the display?The cable connections are located on the back of the display unit. All cables ca

24 E-Series Installation ManualHow do I use the cable splicers?The cable splicers are used to make the connections between the cables easy and secure,

Chapter 3: Installation 25Extension cableIf an extension power cable is required, please note the following:• The wire gauge used may be affected by t

26 E-Series Installation ManualNMEA 0183 cable The NMEA 0183 cable is supplied with exposed wire connecting tails. These should be connected to your e

Chapter 3: Installation 27Composite source typeUse the supplied cable to connect up to 4 composite source inputs to your E-Series Display. The color o

28 E-Series Installation ManualRadar cable (not supplied)Having ensured that the radar scanner you are using is compatible with the E-Series Display (

Chapter 3: Installation 29The array and the display should be connected using the split pedestal cable as shown: ... to repla

Table of ContentsChapter 3: Installation ...173.1 How can th

30 E-Series Installation Manual Pedestal adaptor cable(2.5 metres)PAGEACTIVEWPTSMOBMENUDATACANCELOKRANGEINOUTD7328-1Open ArrayBoats DCPowe

Chapter 4: Commissioning the system 31Chapter 4: Commissioning the system4.1 IntroductionThis chapter details the commissioning of your E-Series Displ

32 E-Series Installation Manual4.3 Pre-start checksBefore you perform any functional tests, please carry out the following pre-start checks:Radar• Che

Chapter 4: Commissioning the system 334.4 Initial power on procedureOnce you have conducted the pre-start checks you are ready to start the display:

34 E-Series Installation Manual1. Press OK to select the highlighted page set.2. Press PAGE. The currently selected page set is represented on the sof

Chapter 4: Commissioning the system 35Bearing alignmentAdjusting the bearing alignment ensures that targets appear at the correct bearing relative to

36 E-Series Installation Manual3. With RADAR SET UP highlighted, use the trackpad (right) to display the RADAR SET UP menu.4. Use the trackpad (up/dow

Chapter 4: Commissioning the system 37This screen provides, for each tracked satellite, the satellite number, a graphical signal strength bar, status,

38 E-Series Installation Manual1. Without a chart card installed, press PAGE.2. Select a full window chart application by pressing the associated key.

Chapter 4: Commissioning the system 394.10 How do I test the video?To ensure that the video application is operating you should open a video applicati

Table of ContentsRadar alignment checks ...34Bearing alignment ...

40 E-Series Installation Manualwww.busse-yachtshop.de | [email protected]

Chapter 5: Troubleshooting 41Chapter 5: TroubleshootingIntroductionThis chapter provides information on troubleshooting your Raymarine E-Series Displa

42 E-Series Installation Manual5.2 How can I get Technical Support?Raymarine provides a comprehensive customer support service, on the world wide web,

Chapter 5: Troubleshooting 43How can I contact Raymarine in the US?You can contact Raymarine in the US either using the Raymarine world wide web as de

44 E-Series Installation ManualIf you wish to enquire about the repair status of your unit, contact the Repair Center at:1-800-539-5539How can I conta

Table of Contentswww.busse-yachtshop.de | [email protected]

Important Information iImportant InformationSafety noticesWARNING:Navigation aidThis product is intended to be used as an aid to navigation. Its accur

ii E-Series Installation ManualCAUTION: Radar Scanners, Cables & InstallationInformation on radar scanners, cables and their installation contain

Important Information iiiEMC ConformanceAll Raymarine equipment and accessories are designed to the best industry standards for use in the recreationa