Raymarine C Series Manual de usuario descargar pdf

Technical Support Article

Article Number - 00016-2011

Date - 18

Jan 2012

Article applies to - All Digital Yacht AIS products with NMEA Input (Multiplexer)

ISSUE: Connecting a Digital Yacht AIS to a Raymarine Classic C Series

The original Raymarine C Series multi-function display (MFD), now referred to as the “Classic” C Series, is a

very popular chart plotter that supports connection to an AIS unit via NMEA 0183. The “Classic” C Series

only has one NMEA 0183 port and this is often connected to other devices, which can cause complications

when a customer wishes to add AIS to the system.

Digital Yacht have designed and tested a number of solutions to this problem and this technical article

details how to connect a Digital Yacht AIS to this popular multi-function display. Only Digital Yacht products

that have an NMEA 0183 input (multiplexer) can be used in some of the solutions we outline in this

document so please check that your Digital Yacht AIS has this feature before purchasing.

SOLUTIONS:

On the rear of the C Series are six connections. The five pin NMEA In/Out cable is the one that we need to

connect the AIS to. The diagram below shows the wire colours and connections.

Check this cable to see if any other equipment is already connected to it. The two most common NMEA

connections to the C Series are;

1) The C Series Output (GPS position) is connected to a DSC VHF

2) The C Series Input is connected to the High Speed Heading output from a Raymarine Autopilot

Course Computer or other compass sensor.

If your installation is configured in either of these two ways, jump to the relevant solution on the following

pages.

1 2 3 4

Technical Support Article Article Number - 00016-2011 Date - 18nd Jan 2012 Article applies to - All Digital Yacht AIS products with NMEA Inpu

*** We strongly recommend that all C Series Classic units are updated to the latest V5.04 software (Oct 2010) as this fixes a number of important AIS

Consult the Raymarine manual for the Raystar 125 on how to configure it to work on NMEA0183 rather than SeaTalk, but the connections you will need to

IMPORTANT NOTE:- The above diagrams are applicable to all Digital Yacht AIS units except the ANT200. For the ANT200 the NMEA output wire is Grey (not

Sin comentarios

Raymarine C Series Manual de usuario