Raymarine VolvoPenta IPS Autopilot System DPU Manual de usuario

Volvo Penta IPS Autopilot SystemDPU Installation and System ConnectionsDocument Number: 87054-1Date: May 200587054_1.fm Page 1 Thursday, June 2, 200

10 Volvo Penta IPS Autopilot System 1.10 Connections to DPUThe diagram below illustrates the connections that are required to and from the

11 SeaTalkUsing the appropriate cable, connect the SeaTalk terminal on the DPU to one of the SeaTalk terminals on the S3G Autopilot. You wi

12 Volvo Penta IPS Autopilot SystemNMEA 0183Connect the NMEA 0183 terminal on the DPU to the NMEA 1 terminal on the S3G course computer. Ensure that t

13The grounding cable is yellow and has a SeaTalk2 connector at one end. Connect this to the FIRST terminal of the 5-way SeaTalk2 connector block. The

14 Volvo Penta IPS Autopilot System Finally, connect to the Volvo Penta system bus using the “MULTILINK” ends of the Y-split cable.

151.14 Post-installation ChecksBefore you proceed to the commissiong stage, it is important to verify your installation. Please follow these simple pr

16 Volvo Penta IPS Autopilot System SeaTalk2 Connector Blockto Volvo Penta AutopilotInterface UnitVolvo Penta IPS AutopilotSystem Connecti

2 Volvo Penta IPS Autopilot SystemHandbook informationTo the best of our knowledge, the information in this handbook was correct when it went to press

3Installation Procedures1.1 IntroductionThe Volvo Penta IPS Autopilot System consists of an IPS S3G Course Computer corepack and an IPS DPU.The IPS S3

4 Volvo Penta IPS Autopilot System1.2 Parts Supplied sAdditional parts requiredTo complete the installation you will also require the Auto

51.3 Planning the installationImportant Safety InformationWARNING: Product installationThis equipment must be installed and operated in accordance wi

6 Volvo Penta IPS Autopilot System1.4 S3G Course ComputerPlease refer to the SmartPilot Commissioning Guide for detailed installation instructions for

71. Remove the outer cover. 2. Place the DPU in the required position and mark the position of the fixing holes.3. Using a 1/8 in (3.5 mm)

8 Volvo Penta IPS Autopilot System1.7 Running SeaTalk & NMEA2000 cablesCable routing practicesWhen running cable, always observe the following gui

9SeaTalk and NMEA2000 connections 1.8 System powerCAUTION: Incorrectly connected power supplies could cause damage to the systemPower will